Contents: 2-1B Mouth Attachments, 4-LOM Chest Armor, C-3PO Removable Limbs Net, Cloud Car Pilot Comm Link, Dagobah Backpack, Emperor Cane, Han Solo Carbonite Block, Hoth Backpack, Logray Shaman Pouch, Lumat Quiver, Survival Kit Gas Mask, Teebo Battle Horn, Ugnaught Tool Box, Warok Quiver, Yoda Cane, Yoda Snake.
2-1B Original Mouth Attachments
The 2-1B Mouth Attachment can be found with different numbers.
Number '1'. No EPM.
Number '2'. With EPM.
Number '3'. With EPM.
Number '4'. With EPM.
Number '7'. No EPM.
4-LOM Original Chest Armor V1
This V1 4-LOM Chest Armor has a serial number ending in a number '4'.
It can also be found with the number '3'.
It can also be found with the number '1' and multiple EPMs.
It can also be found with the number '2' and multiple EPMs.
C-3PO Removable Limbs Lili Ledy Nets - Comparison between REPROs and ORIGINAL
Characteristics of fake nets:
1, Smaller arm holes
2, The circular outside edge line on the arm hole is not smooth as it should be (seems hand cut)
3, Wrong material, too glossy (see fake1)
4, The rectangular inside cuts are hand made
5, The heat seal goes all the way to the top
6, Wrong heat seal mark
Original Lili Ledy C-3PO Removable Limbs Net
CCP Com Link Original V1 - V3 Comparison
CCP Com Link Original V1
Small Circles. Grey / Brown. EPM on reverse.
CCP Com Link Original V2
Medium Size Circles. Light Grey.
CCP Com Link Original V3 - Lili Ledy - Sub-version of V2
Circles like nipples. Dark Grey. Unique to the Lili Ledy Could Car Pilot.
Note: this V3 is actually a sub-version of the V2 mould. The appearance of nipples is thought to be due to it being removed too early from the V2 mould following casting. Because the plastic was not hardened enough it became deformed (nipples instead of circles). More information here: THE LILI LEDY GUIDE & DISCUSSION THREAD PART 1 - Page 36
CCP Com Link REPRO V1
CCP Com Link REPRO V1
Cast in Black.
CCP Com Link REPRO V1
Cast in Blue.
CCP Com Link REPRO V2
Large Circles. Grey.
CCP Com Link REPRO V3
This version is cast from metal, is painted, and sinks.
Dagobah Backpack Original
The Emperor Cane Original
The Emperor Cane REPRO
Painted REPRO. Mass Produced.
Han Solo Carbonite Block Original
Han Solo Carbonite Block REPRO V1
Han Solo Carbonite Block REPRO V2
This repro is very brittle and easily breaks. There are white bubbles present in the moulding and the bottom edge has a 'grounded' type finish.
Original Hoth Backpack
The Hoth Backpack was packaged alongside other accessories and was included in the Survival Kit and the Rebel Transport Vehicle.
Logray Shaman Pouch Original V1
The V1 Logray Pouch has EPMs located on the back of the pouch and strap.
Logray Shaman Pouch Original Top Toys Version V2
Issued with the Top Toys release Logray.
Logray Shaman Pouch V3
The V3 Logray Pouch has no EPMs.
Lumat Original Quiver
Survival Kit Gas Mask Original
Teebo Battle Horn Original
This Teebo Battle Horn has the letter 'G' present on the reverse side.
Also documented: Letter 'F'.
Ugnaught Tool Box Original V1
Updated April 2016.
The V1 Tool Box floats when placed in water and will rise to the surface when submerged. The indented lines on the side panels are not as deep or as wide as the V2 version.The lower indented square is more 'rectangle-shaped' than the V2 as highlighted on the picture below.
Ugnaught Tool Box Original V2
The V2 Tool Box floats when placed in water and will rise to the surface when submerged. The indented lines on the side panels are deeper and wider than the V1 version. The lower indented square is more 'square-shaped' than the V1 as seen on the highlighted MOC example below.
65B - HT code.
Comparison pictures showing some of the differences between the V1 and V2 Ugnaught Tool Box.
Ugnaught's Tool Box REPRO V1
The V1 Repro is currrently under review while TIG awaits further evidence. If you have a suspected reproduction Ugnaught Tool Box please contact us.
Ugnaught's Tool Box REPRO V2
Cast in White Plastic (Not Painted). This repro SINKS when placed in water.
Warok Quiver Original (Not Painted)
Yoda Cane Original V1
A genuine Yoda Cane SINKS.
Note: when first placed on the surface of water it will float ... however, the cane always SINKS when submerged or pressure is applied.
Yoda Cane Original V2 Top Toys version
Yoda Cane REPRO V1
Yoda's Cane REPRO V2
Cast in Dark Brown and Darker Brown plastic.
Yoda Cane REPRO V4
This repro comes in different colours and first appeared on the market in November 2014. It comes from Mexico and is made from resin. The cane sounds like an original during the drop test and fails the float test by sinking when placed in water (note; original Yoda canes also sink). When new, these canes will be very flexible but will harden with age and may even break into pieces under pressure.
Yoda Orange Snake Original V1
Yoda Orange Snake - ORIGINAL versus REPRO
In the picture below the REPRO orange snake is cast from Orange Plastic and is virtually identical to its original counterpart.
Note: the genuine orange snake will SINK when placed into water. This REPRO will FLOAT. There also appears to be a more sharp definition to the eyes and scales of this repro compared to the original, as well as a slight difference in colour.
Yoda Lighter Orange Snake Original V2
The V2 is a lighter orange colour.
Comparison of V2 lighter orange snake (left) with a V1 orange (right).
Yoda Dark Brown Snake Original V3
The darker brown Yoda snake is made from a more flexible/soft material than the orange snakes. It will sink when placed in water.
Yoda Lighter Brown Snake Original V4
The lighter brown Yoda snake is also made from a flexible/soft material and will sink in water.
Yoda Snake Original V5 Top Toys version
Yoda "Green" Snake
Not a true variant. TIG believes the 'Green" Yoda Snake to be nothing more than degradation as the plastic of the Brown Yoda Snake slowly turns "Green".
The missing link. A Brown Snake turning "Green".
Colour comparison including the degraded "Green" Yoda Snake.
Yoda Snake REPRO V1
Cast in Dark Grey Metal and Painted Brown. Much heavier than originals.